SE130 Tunnel thruster, 24V

SE130 Tunnel thruster, 24V
130kg thrust ON/OFF

SE130 is our smallest model in the 250mm tunnel range, and the model is very silent because of reduced speed of water flow through the tunnel. If your boat need 100kg+ thrust and can fit a 250mm tunnel, SE130 will be a perfect solution. The SE130/250T includes all the important and unique Side-Power features and qualities - why settle for less

Side-Power Intelligent Power Control

Intelligent Power Control

The Side Power unique thruster controller that intelligently protects the thruster from potential inherent problems in all high current applications as well as user faults. It includes several important safety features imperative in a product with such high power, run by DC electrics, as a thruster.

  • Provides delay between drive directions
  • Monitors solenoid functions to reduce the chance of solenoid lock-in
  • Will stop the thruster in case of a lockedin solenoid, without extra user action and even without controlling a main switch.
 

 
Side-Power Q-prop™

Q-prop™

The new 5 blade special skew propellers are the result of over 2 years of development work and thousands of tests. They have been designed to reduce the noise level, while maintaining the exceptional efficiency of the old 4 blade Side-Power propellers. This goal was achieved, and we even chose to make them a little bit more aggressive on some models, increasing the thrust on some thrusters about 5%. Please see individual information on each new thruster for more details.

  • Noise reductions of up to 75% measured in controlled environments
  • The expected and tested normal noise reduction in average installations: 20-40%
  • Will be delivered on all Side-Power models except models with 300mm and 385mm tunnel diameter
  • Upgrade kits are available for most SP series thrusters with special adaptors
 

 
Side-Power Sealed Drive

Sealed and lifetime lubricated gearleg

Sealed gearleg with long-life "mechanical" seal where highly polished ceramic and carbon surfaces form the only moving sealing surfaces, ensuring protection against damaging water intrusion into the gear leg. Pre-filled with special gear oil for lifetime lubrication.

  • "Mechanical" seals with surfaces of ceramic and carbon for ultimate security against water intrusion
 

 
Side-Power Twin Propellers

Twin Propellers

The twin propeller system can give more thrust than a single propeller system in the same tunnel diameter. This is our choice for our mid-range models where high thrust is required in a small tunnel diameter. Due to the compact design and high performance, the twin models have become the thrusters of choice among boat builders around the world.

 

 
Side-Power Galvanic Separation

Galvanic Separation

The gearhouse / drive legs of most Side-Power DC Electric thrusters are now fully galvanically isolated / separated from the electric motor and motor bracket. This ensures that even if there is an accidental short circuit or a current leak for other reasons, the immersed parts are not effected as they could be with direct electric contact.

  • Achieved by composite bushings around the bolts and beneath the washers and a bushing in the motor bracket electrically isolating the drive housing from the motor bracket.
  • Available on DC electric models with flexible couplers only, where the flexible coupler provides galvanic separation of the motor and gearleg shaft.
Thrust at 21V* (kg) 130
Thrust at 24V* (kg) 160
Typical boat size (ft • m) 42’ - 62’ • 16 - 19
Tunnel inner diameter (mm) 250
Propulsion Twin
Power at 10,5/21V* (kW • Hp) 6,5 • 8,7
For DC system (V) 24
Weight (kg) 37
Min. battery capacity (CCA**12/24V) 750/440
Control system Analog

* All Side-Power thrusters gets their thrust rating from the actual performance you can expect in a boat - at the voltage a normal installation will provide at the thruster. We have choosen to use the net performance at 10.5V/21V, but we also list the effect at 12/24V for comparison.

** All battery CCA ratings are stated with the DIN rating, multiply by 1.9 to to get the SAE equivalent (at 0ºF, ABYC standard)

Measurements Tunnel Thruster

A (mm · in) 250 · 9,84
B (mm · in) 398 · 15.7
C (mm · in) 245 · 10.0
D (mm · in) 256 · 10.1
E min (mm · in) 230 · 9.0
F (mm · in) 280 · 11.0
F recommended (mm · in) 560 · 22.0
G min. (mm · in) 7 · 0.28
G max. (mm · in) 10 · 0.39   

Measurements Stern Thruster (Stern tunnel kit sold separately)

 

SE Series, Measurements, Side-Power Thruster System

I (mm · in) 359 · 14.13
II (mm · in) 340 · 13.4
III min. (mm · in) 250 · 9.84
IV max. (mm · in) 60 · 2.36
V (mm · in) 200  · 7,8
VI (mm · in) 350 · 11,8
Tunnel length (mm · in) 350  · 13,87

# Description Product
1 Propeller 10 1271 RH
2 Propeller drivepin 9 1241
3 Propeller washer 20 1181
4 Locknut 10 1260
5 Anode 20 1180 A
6 Gasket 9 0610
7 Driveshaft key 10 1440
8 Gearleg bolt 10 1080
9 Complete gearleg 9 0601
10 Complete motor bracket 10 0501
11 Complete flexible coupling 7 1463
12 Brushes for motor (kit)** **
13 Brush springs for motor (kit)** **
14 Electric motor N/A
15 Key for eletric motor shaft 10 1440
16 Solenoid bracket kit 10 0140 24
17 Electronic control box 6 1232 I
18 Internal wiring loom 6 1226 B
19 Solenoid 41371243
20 Complete solenoid kit 10 0131 24
21 Solenoid Cover 8 2026
22 Nut for solenoid cover 6 8810
23 Complete electric motor assembly 9 0101 24
24 Temp switch* *

Footnotes

12 ** Please provide thruster serial # when ordering brushes and brush springs.
13 ** Please provide thruster serial # when ordering brushes and brush springs.
24 * Please provide thruster serial # when ordering Temp switch.

The installer alone has responsibility for the installation of the spare parts. Side-Power only warranty the spare parts supplied only.

The information given in the document was correct at the time it was published. However, Sleipner Motor AS can not accept liability for any inaccuracies or omissions it may contain. Continuous product improvement may change the product specifications without notice. Therefore, Sleipner Motor AS can not accept liability for any possible differences between product and document.

File Type Language Download
Product specification sheet_DC_thrusters.pdf Product sheet English  Download
(INSTALLATION MANUAL) (SE) (80, 100, 120, 130, 150).pdf Installation Manual English  Download
(USER MANUAL) (SE & SE-IP).pdf User Manual English  Download
CAD-files & technical drawings

3D models & technical drawings
for industry professionals

At Sleipner, we have shared our knowledge and technology with naval architects and boat builders for over a century. Now, we have also decided to open up our complete library of .cad, .igs, .dwg, .dxf, .stp, .xt, .pdf files and more.

Get access to 1000+ CAD files

Related products and categories